12/16/2023 0 Comments Litter robot timing lightAnd it starts after 15 seconds of your cat’s left.Īlso, if the bonnet is removed or disconnected, this may show the slow yellow light flashing. The sensor detects it and pauses the process. Which indicates, “The clean cycle is interrupted” So many times, the cats try to enter the globe while it’s in cycling. So, you need to check that out before starting to troubleshoot, at the very beginning.Ī yellow light generally indicates “The Cycle is Paused.” Though it can flash yellow lights in two waysįlashing Slowly- this slow flash is about once per second. Try shaking the drawer to level the waste in that case. It could be a reason for the continuous blinking even if the drawer is not full. Check on the sensor eye if you are around it. You should know that wastes often get stuck on the side of the waste drawer. Maybe you need to repair your device from a service center. Now, if the sensors are clean, there is no dust in the drawer. If the blue light is blinking now, the drawer is somehow removed. Make sure any dirt or obstacles is not blocking the sensor.Press the cycle button (Removing the waste drawer).It may work on the issue.Īnd still not working properly? Not indicating the solid blue light flashing? If it is still not working properly, Try Recalibrating the sensors.But be confirmed at least after two to three cycles.If it cycles and the light turns blue.If your device doesn’t cycle automatically, Press “Cycle.”.If you find a black key on the back of the globe, place it at the back of the base.You can wipe the sensor eye with a tissue, a paper towel, or even a lite glass cleaner. There are two green circuit boards on the same side. Now find the Drawer Full Indicator component you will find it in the center of the base.Remove the bonnet and globe to get easy access to the DFI component.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |